Help
Help us to make a smile on every face !!! Donate Now
CLOSE ADS
CLOSE ADS

Why Navigation light rules

The business and transport from sea is continued from many centuries of year ,but in The mid of 19th century big and powerful countries feel the need of some rules and light navigation system to avoid accident in night and bad weather conditions.

In 1838 the United States passed an act requiring steamboats running between sunset and sunrise to carry one or more signal lights; colour, visibility and location were not specified. In 1846 the United Kingdom passed legislation enabling the Lord High Admiral to publish regulations requiring all sea-going steam vessels to carry lights. The admiralty exercised these powers in 1848 and required steam vessels to display red and green sidelights as well as a white masthead light whilst under way and a single white light when at  anchor.

     In 1849 the U.S. Congress extended the light requirements to sailing vessels. In 1889 the United States convened the first International Maritime Conference to consider regulations for preventing collisions. The resulting Washington Conference Rules were adopted by the U.S. in 1890 and became effective internationally in 1897. Within these rules was the requirement for steamships to carry a second mast head light. The international 1948 Safety of Life at Sea Conference recommended a
mandatory second masthead light solely for power driven vessels over 150 feet in  length and a fixed sternlight for almost all vessels. The regulations have changed little since then. 

       The International Regulations for Preventing Collisions at Sea established in 1972 stipulates the requirements for the navigation lights required on a vessel.

- Basic lights: 
    To avoid collisions, vessels mount
navigation lights that permit other vessels to determine the type and relative angle of a vessel, and thus decide if there is a danger of collision. In general sailing vessels are required to carry a green light that shines from dead ahead to 2 points( 221⁄2°) abaft[note 1] the beam on the starboard side (the right side from the perspective of someone on board facing forward), a red light from dead ahead totwo points abaft the beam on the port side (left side) and a white light that shines from astern to two points abaft the beam on both sides. Power driven vessels in addition to these lights, must carry either one or two (depending on length) white masthead lights that shine from ahead to two points abaft the beam on both sides.

If two masthead lights are carried then the aft one must be higher than the forward one.
Small power driven vessels (under 12 metres (39 ft)) may carry a single all-round white light in place of the two or three white lights carried by larger vessels, they must also carry red and green navigation lights. Vessels under 7 metres (23 ft) with a maximum speed of less than 7 knots are not required to carry navigation lights, but must be capable of showing a white light.[4] Hovercraft at all times and some boats operating in crowded areas may also carry a yellow flashing beacon for added visibility during day or night.

 Lights for specific signals:
         In addition to red, white and green running lights, a combination of red, white and green Mast Lights placed on a mast higher than all the running lights, and viewable from all directions, may be used to indicate the type of craft or the service it is performing. See "User Guide" in external links.
Ships at anchor display one or two white anchor lights (depending on the vessel's length) that can be seen from all directions. If two lights are shown then the forward light is higher than the aft one. Boats classed as "small" are not compelled to carry navigation lights and may make use of a handheld torch.

Airplane navigation lights:
      
 In 1919 after worldwar 1 every cuntary is wants to make thereself leader in aircraft manufacturing race. To the need of some rules is feel by powerful alies. The start to follow the sea vessels navigation light rules near the mid of 20th century because they are accurate and mature by years of experience and in the sky or sea the wavelength and visibility of light is not nearly same , Soo their are no need to change the colour of lights. Aircraft external lights are any light fitted to the exterior of an aircraft. They are usually used to increase visibility to others, and to signal actions such as entering an active runway or starting up an engine.

Historically, incandescent bulbs have been used to provide light, however recently Light-emitting diodes have been used. Aircraft navigation lights follow the convention f marine vessels established
a half-century earlier, with a red navigation light located on the left wingtip leading edge and a green light on the right wingtip leading edge. A white navigation light is as far aft as possible on the tail or each wing tip. High-intensity strobe lights are located on the aircraft to aid in collision avoidance.
Anti-collision lights are flashing lights on the top and bottom of the fuselage, wingtips and tail tip. Their purpose is to alert others when something is happening that ground crew and other aircraft need to be aware of, such as running engines or entering active runways. In civil aviation, pilots must keep
navigation lights on from sunset to sunrise. High-intensity white strobe lights are part of the anti-collision light system, as well as the red rotating beacon. All aircraft built after 11 March 1996 must have an anti-collision light system (strobe lights or rotating beacon) turned on for all flight activities in poor visibility. The anti collision system is recommended in good visibility, where only strobes and beacon are required. For example, just before pushback, the pilot must keep the beacon lights on to notify ground crews that the engines are about to start. These beacon lights stay on for the duration of the flight. While taxiing, the taxi lights are on. When coming onto the runway, the taxi lights go off and the landing lights and strobes go on. When passing 10,000 feet, the landing lights are no longer required, and the pilot can elect to turn them off. The same cycle in reverse order applies when landing. Landing lights are bright white, forward and downward facing lights on the front of an aircraft. Their purpose is to allow the pilot to see the landing area, and to allow ground crew to see the approaching aircraft. Civilian commercial airliners also have other non-navigational lights. These include logo lights, which illuminate the company logo on the tail fin. These lights are optional to turn on, though most pilots switch them on at night to increase visibility from other aircraft. Modern airliners also have a wing light. These are positioned on the outer side just in front of the engine cowlings on the fuselage. These are not required to be on, but in some cases pilots turn these lights on for engine checks and also while passengers board the aircraft for better visibility of the ground near the aircraft. While seldom seen, the International Code of Signals allows for the exclusive use of a flashing blue lights (60 to 100 flashes/minute) and visible from as many directions as possible, by medical aircraft to signal their identity .
.

Play in Youtube
Credit: Bhupinder Singh

You May Also Like These

Post a Comment

Spam Not Allowed. We accepting Guest Posts. Any Doubts write us mail@kasworld-aero.ml


Share :

Advertisement